Dead Arm with 3 Way Bracket

Hi-Line Part-Number: HS7674

Temporary Dead End Arm. The Temporary Dead End Arm enables a line crew to spread conductors off an existing dead end arm to gain working clearance to replace and terminate new conductors.


  • Arms are constructed with 3” diameter fiberglass and a foam core to meet most load requirements for temporary dead ends
  • Load limit - 500 lbs. per position or 1,000 lbs. total load limit
  • Arms have two holes with 18” spacing to accommodate 5/8” diameter hardware bolts for dead ends. Two aluminum sleeves are installed to prevent wear on the fiberglass arm
  • Steel mounting brackets have multiple holes for adjustment to fit various arm sizes. Note: adjustment range is described for all catalog numbers shown below. • Arms can be installed on either the top or bottom of existing cross arms
  • Two styles are available. Butt swivel eye to dead end a single phase tap line or a 3 way aluminum alloy equipment mounting bracket for mounting a cutout, lighting arrester and a dead end tap line
  • When utilizing the butt swivel or the equipment mounting bracket for temporary hanging of a tap line; only slack spans are recommended with loads not to exceed 150 lbs., providing that the Dead End Arm is being held captive on the crossarm
  • Height Adjustment: 4 5/8”, 4 7/8”, 5 7/8”, 6 1/8”
  • Width Adjustment: 3 7/8”, 5”, 6 1/8”
  • Weight: 34 lbs

List Price: Call for Pricing

California Proposition 65

PVC-coated Products; PVC-coated Wires and Cables

WARNING: This product can expose you to chemicals including DINP and/or DEHP, which are known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov or our information page: California Proposition 65.